diff --git a/platform/avr-ravenlcd/raven3290.c b/platform/avr-ravenlcd/raven3290.c
index a122f44d4..a3ed6140f 100644
--- a/platform/avr-ravenlcd/raven3290.c
+++ b/platform/avr-ravenlcd/raven3290.c
@@ -1,15 +1,15 @@
/**
- * \mainpage ATmega3290p LCD Driver Software for Raven
+ * \section ATmega3290p LCD Driver Software for Raven
*
*
- * \section intro_lcd LCD Introduction
+ * \subsection intro_lcd LCD Introduction
*
* This Raven LCD Driver application software was designed for a user interface
* to the Contiki 6LoWPAN collaboration on board the ATmega3290p. The
* LCD functionality uses the binary command set described in the release notes.
* These binary commands can also be found in a list of main.h.
*
- * \section compile_lcd Compiling Raven LCD Driver
+ * \subsection compile_lcd Compiling Raven LCD Driver
*
* Raven LCD Driver can be compiled on the following platforms:
*
@@ -24,7 +24,7 @@
* toolchain.
* -# IAR EWB-AVR. is currently not supported.
*
- * \section fuses Board fuse settings
+ * \subsection fuses Board fuse settings
*
* The Raven LCD (3290p device) requires the proper fuse settings to function
* properly. These settings have been summarized below:
@@ -33,7 +33,7 @@
* -# High: 0x99 (JTAG and ISP enabled, No OCDEN or EEPROM saving required)
* -# Low: 0xE2 (Use Int RC OSC - Start-up Time:6CK + 65ms)
*
- * \section notes Operation Release Notes
+ * \subsection notes Operation Release Notes
*
* After programming the Raven LCD 3290p with the proper image, you will be introduced to
* the menu in the picture below:
@@ -56,7 +56,7 @@
* to the webserver for Sensor Reading Data (Once or Auto). The webserver will
* only update the html data when refreshed.
*
- * \section binary Binary Command Description
+ * \subsection binary Binary Command Description
*
* Using the binary commmand list described in main.h, the 3290p will contruct a binary
* command serial frame to control the 1284p. An example command frame is contructed below: