History

George Oikonomou 024586c21a Allow the MQTT client example for platform native		2018-04-02 22:14:55 +01:00
..
arch	Allow the MQTT client to build & work without platform-specific extensions	2018-04-01 16:53:12 +01:00
Makefile	Allow the MQTT client example for platform native	2018-04-02 22:14:55 +01:00
mqtt-client.c	Allow the MQTT client to build & work without platform-specific extensions	2018-04-01 16:53:12 +01:00
mqtt-client.h	Cross-platform MQTT client example	2018-03-23 22:35:28 +00:00
project-conf.h	Cross-platform MQTT client example	2018-03-23 22:35:28 +00:00
README.md	Cross-platform MQTT client example	2018-03-23 22:35:28 +00:00

README.md

MQTT Client Example

The MQTT client can be used to:

Publish sensor readings to an MQTT broker.
Subscribe to a topic and receive commands from an MQTT broker

The demo will give some visual feedback with a LED (configurable):

Very fast blinking: Searching for a network
Fast blinking: Connecting to broker
Slow, long blinking: Sending a publish message

This example is known to work with all platforms that support the new button API.

Publishing

By default the example will attempt to publish readings to an MQTT broker running on the IPv6 address specified as MQTT_DEMO_BROKER_IP_ADDR in project-conf.h. This functionality was tested successfully with mosquitto.

The publish messages include sensor readings but also some other information, such as device uptime in seconds and a message sequence number. The demo will publish to topic iot-2/evt/status/fmt/json. The device will connect using client-id d:contiki-ng:mqtt-client:<device-id>, where <device-id> gets constructed from the device's IEEE address.

Subscribing

You can also subscribe to topics and receive commands, but this will only work if you use "Org ID" != 'quickstart'. To achieve this, you will need to change 'Org ID' (DEFAULT_ORG_ID). In this scenario, the device will subscribe to:

iot-2/cmd/+/fmt/json

You can then use this to toggle LEDs. To do this, you can for example use mosquitto client to publish to iot-2/cmd/leds/fmt/json. So, to change the state of an LED, you would do this:

mosquitto_pub -h <broker IP> -m "1" -t iot-2/cmd/leds/fmt/json

Where broker IP should be replaced with the IP address of your mosquitto broker (the one where you device has subscribed). Replace -m "1' with -m "0" to turn the LED back off.

Bear in mind that, even though the topic suggests that messages are of json format, they are in fact not. This was done in order to avoid linking a json parser into the firmware. This comment only applies to parsing incoming messages, outgoing publish messages use proper json payload.

IBM Quickstart Service

It is also possible to publish to IBM's quickstart service. To do so, you need to undefine MQTT_DEMO_BROKER_IP_ADDR.

The device will then try to connect to IBM's quickstart over NAT64, so you will need a NAT64 gateway in your network to make this work. A guide on how to setup NAT64 is out of scope here.

If you want to use IBM's cloud service with a registered device, change 'Org ID' (DEFAULT_ORG_ID) and provide the 'Auth Token' (DEFAULT_AUTH_TOKEN), which acts as a 'password', but bear in mind that it gets transported in clear text.